Can AI take a PCB from a prompt to a finished, checked board?

Yes, with a guide that keeps the agent honest. An AI agent can place parts and route traces, but on a long job it skips steps, forgets what it checked, and calls a board done too early. AI Flow is a free, open-source tool from Adom that walks your agent through every step of a board in Adom Hydrogen, hands it ready-made code for the routine parts, checks its work, and records the whole run.

Start a run

In Hydrogen, click AI Flow in the dock, or paste this into your agent:

Start an AI Flow run with me.

The agent installs AI Flow, asks which board to build or continue (a KiCad or Fusion 360 project, or a new design from a short brief), and opens a live timeline beside the chat so you can watch each step land.

What the run covers

  1. Parts. The agent sources parts through Adom Parts Search (Mouser, DigiKey and JLCPCB, with stock) and pulls symbols, footprints and 3D models from the Adom Wiki. A part the wiki doesn’t have yet can be requested and built.
  2. Placement. Courtyard and packing checks compare every DRC finding against the starting board, not just the count.
  3. Routing and pours. AI Flow’s router and pour planner turn the plan into copper, with thermal and stitching vias from your spec, and KiCad’s own DRC runs on the result.
  4. Silkscreen. Grouped references, connector and test-point labels, and board documentation on both sides.
  5. Analysis. Current and heat are solved with Adom Fields. A copper pour’s area alone isn’t accepted as proof that it carries the current.
  6. Delivery. The run ends with a short video of every step, the AI’s own current-density and temperature drawings, and the run and step clocks.

Every placement, trace and pour lands live in your own EDA tool through its bridge, so you can stop the run at any point and open the board yourself.

What it checks, and what it doesn’t

AI Flow’s checks are suggestions, not walls: each one reports what it found and the next thing to try, and you and the agent decide what to do. It doesn’t call a run a result until the board is delivered, and if inputs change after an analysis, that analysis no longer counts.

It’s an engineering screen, not a certification. Review the board, the DRC report and the datasheets before you order, as you would for any design.

Which EDA tools it runs on

KiCad is the most proven path, demonstrated on the ESC G431 motor controller. Fusion 360 boards run through the Fusion Bridge. Altium support is on the roadmap, and the AI Flow page lists what’s planned and in what order.

For results from AI agents placing the ESC G431, see Can Claude Code design a PCB?