Can an AI check current, heat and EMC on my PCB?
Yes. Adom Fields solves where the current and the heat go on your board from the board file itself, paints the result on the board in 3D, and ends with a review your AI agent can act on. It runs in Adom Hydrogen and reads KiCad boards (.kicad_pcb) and Fusion 360 boards saved as EAGLE source (.brd). An Altium reader is planned.
What it checks
- Current density on every loaded net, solved on the filled copper of every layer and through the vias, with the peak and where it is.
- Heat and temperature: where the watts travel from the hot parts, and the rise above room temperature in still or moving air, with each part’s 3D model standing in its hot spot.
- An EMC screen: the switching hot loop and the smallest it could be, copper with no ground under it, an estimate of the loop’s emissions against the FCC Class B limit, decoupling at each chip power pin, and connector pins with no ESD protection.
- Ground and power: ground’s own voltage drop, possible ground loops, floating islands, gaps in the stitching-via fence, and each rail’s impedance from 1 kHz to 1 GHz.
- Signals: capacitance between facing copper, differential-pair length skew and microstrip estimates.
Each view can explain itself out loud with your board’s own numbers.
Fix it, then prove it
Every solve ends with a list of findings, such as a current neck, a hot tab or a missing thermal via, each with a suggested fix. Ask your agent to apply one, and adom-fields verify makes the change on a copy of the board, has KiCad refill the zones and run DRC on both boards, solves both, and reports which issues cleared and every number that moved. On the four-layer ESC G431, four thermal vias under each of two FETs cut one FET’s temperature rise from 90.8 °C to 86.0 °C with no new DRC errors.
Try it
Ask your agent in Hydrogen:
Install adom/adom-fields, run it on my board, and show me the current density on the main power net.
Or from a terminal:
adom-wiki pkg install adom/adom-fields
adom-fields analyze --board board.kicad_pcb --spec spec.json --out fields
The spec lists the currents and the parts that get hot. A solve takes a couple of minutes.
What it is, and isn’t
Adom Fields is a design screen. It lists every input it had to assume, most important first, along with the datasheet field that would replace it, and its emissions predictions come with an uncertainty band. Use it to find problems early and to rank fixes, and keep your lab tests for compliance.
It’s also the analysis step of AI Flow, which doesn’t accept a copper pour’s size as proof that it can carry the current.